This model was made as one complete mesh and is ready to be downloaded, sprued, sliced, and printed.
The current model was made to a US finger size or 7 3/4 - 8; sitting in that sweet spot for most male and female finger sizes. The model can also easily be scaled and adjusted in software before printing.
The crown pattern only stretches about half way around the ring before transitioning into the lower half of the shank. This leaves enough of a sizing stock to easily be sized after printing.
The width of the ring is just a hair over 7mm wide. With the top of the shank being 2mm thick and tapering down to 1.4mm thick in the back. This leaves enough room for shrinkage and clean up after printing and casting.
The file being downloaded is a .zip file and contains the stl and obj file file ready to be sprued and printed.
By downloading our digital item you are agreeing to our Terms and Service. All digital purchases made from Moore’s Jewelers and mooresjewelers.com may not be resold, redistributed, or reuploaded by any party other than Moore’s Jewelers.
There are no returns for files that have been downloaded. If you have purchased a file by mistake and have not downloaded it please to contact us and we will be more than happy to issue a full refund.
If you have any questions or experience any issue do not hesitate to contact us. We would be more than happy to help!
